Tongue And Groove Gate Plans

To produce the tongue the spindle block is lifted and then the boards go through face down.

Tongue and groove gate plans.

Next with the tongues and grooves on all the boards grab the board with only a tongue moulded on and the board with only a groove within it as we need to run a chamfer on the. This timber is called 4 x 1 treated timber in the builders yards and timber merchants where you will find it is a lot cheaper than places like homebase and b q. The gate we are making is made from treated sawn timber planks which are 100mm wide and 25mm thick. Use a 3 4 inch chisel to clear out any material in the groove.

In a router you can ignore this as the boards should go through face down. Match the tongue on one board with the groove on the other board. Unfinished pine tongue and groove shiplap siding board 6 pack model 276588 view the ufp edge unfinished tongue groove. Flip the boards over and repeat on the other face.

Reset the height of the table saw blade to 3 8 inch set the fence at 3 4 inch and cut the face of each short side of each board. Next we ll cut the tongue that will make up this tongue and groove joint. Lay nine pieces of tongue and groove wood face down parallel to each other on a flat surface. Plus the tongue and groove cedar boards ensure privacy as no one will be able to peek through slats in the gate.

This project provides instructions to create a 42 inch wide cedar wood gate that will add style and function to a fence.